I don’t know about anyone reading, but personally I can be incredibly nosey and it occurred to me the other day that I’ve absolutely no idea what is actually inside some of the tat I’m writing about. I don’t have much past a rudimentary understanding of electronics (more than enough to work on the average PC or service a Commodore 64) but that’s never stopped me from dismantling things before so, pausing only to grab a passing screwdriver and my (t)rusty digital camera, here’s what the innards of a Megajoy 2 look like! Y’know, it’s ideas like this that lead to occasional features for websites…

Step 1: the battery compartment is removed
To start with, the battery compartment pops out of the base – literally since it’s spring-loaded! To actually dismember the thing, there are eight screws recessed into the plastic that need removing, five spread out over the three handles of the controller and a further three positioned around the housing for the battery box.

Step 2: the screws and lower case are removed
The screws are removed and the lower part of the case lifted away, leaving the upper and all of the innards in place. Taking a few fairly educated guesses, the larger of the two PCBs appears to drive the input and output whilst the smaller takes care of actually running the games; from what I’ve read previously one of those two blobs of black epoxy will be covering the NOAC itself and I assume that the ROM where the games are stashed is under the other.

Step 3: the board is removed and turned over
Here’s the other side of the board that deals with I/O, there are four contacts on it for the D pad to the left, a single contact just below the red power LED in the middle and a further six to the right for the select, start and the two pairs of A and B buttons. At the back of the board on the left are a couple of composite video connectors and the DC input and power switch (without the yellow plastic cover which has been removed and is sat by the screws) are on the right.

Step 4: the board is moved aside to show contacts under the controls
And finally, here’s the board itself moved away from the shell so the underside of the D pad and buttons are fully visible; the two wires still attached are for the springs that press against the terminals on the battery compartment to provide power. And after all of this mauling, the Megajoy 2 went back together with reasonable ease as well, anyone would think that I actually knew what I was doing…!


